|
|
PDF EM8633 Data sheet ( Hoja de datos )
| Número de pieza | EM8633 | |
| Descripción | PWM Controller | |
| Fabricantes | Excelliance MOS | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de EM8633 (archivo pdf) en la parte inferior de esta página. Total 12 Páginas | ||
|
No Preview Available !
EM8633
Green mode PWM Flyback Controller with External Over
Temperature Protection
General Description
EM8633 is a high performance, low startup
current, low cost, current mode PWM controller
with green mode power saving. The EM8633
integrates functions of Soft Start(SS), Under Voltage
Lockout(UVLO), Leading Edge Blanking(LEB),
internal and external Over Temperature
Protection(OTP), internal slope compensation. The
EM8633 also features more protection like Over
Load Protection(OLP) and Over Voltage
Protection(OVP) to prevent circuit damage
occurred under abnormal conditions.
The EM8633 provides the users a superior
AC/DC power application of high efficiency,
excellent EMI performance, low external
component counts and lower cost solution.
Ordering Information
Part Number
EM8633J
Package
SOT-23-6
Remark
Typical Application Circuit
Features
Ultra Low Start Up Current (6uA)
Current Mode Control
Soft Start Function
Built-in Slope Compensation
Internal Leading-edge Blanking
Over Voltage Protection (OVP) on VDD pin
Over Load Protection (OLP)
Cycle-by-cycle Current Limit
Feedback Open Protection
External Over Temperature Protection (OTP)
Internal Over Temperature Protection (OTP)
Constant Output Power Limit (Full AC Input
Range)
Internal Frequency Jittering for Excellent
EMI Performance
Gate Voltage Clamping
Applications
Switching AC/DC Adaptor and Charger
Open-Frame SMP
AC
INPUT
EMI
Filter
DC
+ OUTPUT
LATCH
COMP
VDD
EM8633
GATE
CS
GND
2013/05/13
A.1
1
1 page  
Electrical Characteristics
(VDD=15V, TA=25℃, unless otherwise specified)
Parameter
Symbol
Test Conditions
VDD Section
VDD OVP Protect voltage
Start up Current
VDD On Threshold Voltage
VDD Off Threshold Voltage
VDD Reset Threshold Voltage
Operating Supply Current 1
Operating Supply Current 2
Operating Supply Current 3
VOVP
ISTART1
ISTART2
VTH-ON
VTH-OFF
VRESET
IDD-OP1
IDD-OP2
IDD-OP3
VDD=7V
VDD= VTH-ON -0.5V
VDD=15V, VCOMP=0V,
VDD=15V, VCOMP=3V,
CGATE=1nF
VDD=15V,
Protection triggerred
Gate Section
Rising Time
Falling Time
Current-Sense Section
Maximum Internal Current
Setpoint
Leading Edge Blanking Time
Propagation Delay Time
Soft-Start Period
Internal Oscillator
TR CL = 1nF
TF CL = 1nF
VCSLim
TLEB
TPD
TSS
Oscillation Frequency
Maximum Duty
Green mode Minimum
Frequency
Frequency Jittering
Frequency Variation vs. VDD
fOSC
Dmax
VCOMP=3V, VCS=0V
fjitter
VDD=11V to 25V
Frequency Variation vs.
Temperature
-20℃ to 105℃(Note4)
Min Typ
27 28
-1
-6
13.5 15
7.5 8.5
6
-2
- 2.5
- 0.75
- 150
- 30
0.8 0.85
200 300
100
2
60 65
70 75
22
±6
EM8633
Max Units
29 V
2 uA
15 uA
16.5 V
9.5 V
V
3 mA
- mA
- mA
200 nS
100 nS
0.9 V
400 nS
nS
mS
70 KHz
80 %
KHz
%
3%
3%
2013/05/13
A.1
5
5 Page 
Over Voltage Protection (OVP) on VDD
The EM8633 are implemented a
Over-Voltage-Protection (OVP) on VDD.
Whenever the VDD voltage is higher than the
OVP threshold voltage (28V), the output gate
drive will be shutdown to stop the switching of
the power MOSFET until the next UVLO (on).
The Over-Voltage-Protection on VDD function in
EM8633 is an auto-restart type protection. If the
OVP condition is not released, the VDD will
tripped the OVP level again and re-shutdown
the gate output. The VDD is working as a hiccup
mode as shown in Fig. 16. On the other hand, if
the OVP condition is removed, the VDD level will
go back to normal level and the output will
automatically return to the normal operation.
VDD
OVP level
UVLO (on)
UVLO (off)
Gate out
t
EM8633
or lower. If the external latch shutdown function
by the LATCH pin is not to be used, let this pin
floating or connecting a capacitor only.
Connect an NTC resistor to the LATCH pin to use
the over-temperature protection. (Fig. 17)
Vb ias
LATCH
3
100uA
1.1V
160uS LATCH
Debounce
Fig.17
No Switch out
Fig. 16
t
Internal Over-Temperature Protection (OTP)
Internal 160℃ comparator will provide over
temperature protection (OTP). OTP will
shutdown system, until VDD below UVLO(low).
The system will hiccup, if the internal
temperature always higher than 160℃.
External Over-Temperature Protection (OTP)
The LATCH pin is equipped with a latch
shutdown function. (Fig. 17) By decreasing the
LATCH pin voltage to 1.1V or lower, the IC
enters the latch mode. To reset latch mode,
remove the AC power line, thus decreasing the
VDD voltage to the Reset Threshold Voltage (6V)
2013/05/13
A.1
11
11 Page | ||
| Páginas | Total 12 Páginas | |
| PDF Descargar | [ Datasheet EM8633.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| EM8631 | PWM Controller | Excelliance MOS |
| EM8632 | PWM Controller | Excelliance MOS |
| EM8633 | PWM Controller | Excelliance MOS |
| EM8633L | PWM Controller | Excelliance MOS |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |