DataSheet.es    


PDF NL10276BC30-39 Data sheet ( Hoja de datos )

Número de pieza NL10276BC30-39
Descripción TFT COLOR LCD MODULE
Fabricantes NEC 
Logotipo NEC Logotipo



Hay una vista previa y un enlace de descarga de NL10276BC30-39 (archivo pdf) en la parte inferior de esta página.


Total 29 Páginas

No Preview Available ! NL10276BC30-39 Hoja de datos, Descripción, Manual

TFT COLOR LCD MODULE
NL10276BC30-39
38cm (15.0 Type)
XGA
LVDS interface (1port)
PRELIMINARY DATA SHEET
DOD-PP-1265 (3rd edition)
This PRELIMINARY DATA SHEET is updated
document from DOD-PP-1249(2).
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-1265 (3rd edition)
Published date: September 2011 CP(N)
1
© NLT Technologies, Ltd.
2011 All rights reserved.

1 page




NL10276BC30-39 pdf
NL10276BC30-39
2. GENERAL SPECIFICATIONS
Display area
Diagonal size of display
Drive system
Display color
Pixel
Pixel arrangement
Dot pitch
Pixel pitch
Module size
Weight
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface
Polarizer pencil-hardness
Color gamut
Response time
Luminance
304.128 (H) × 228.096 (V) mm
38cm (15.0 inches)
a-Si TFT active matrix
16,777,216 colors (6bit+FRC)
1,024 (H) × 768 (V) pixels
RGB (Red dot, Green dot, Blue dot) vertical stripe
0.099 (H) × 0.297 (V) mm
0.297 (H) × 0.297 (V) mm
326.5 (W) ×253.5 (H) × 11.7 (D) mm (typ.)
(970)g (typ.)
(900):1 (typ.)
At the contrast ratio 10:1
Horizontal: Right side 88° (typ.), Left side 88° (typ.)
Vertical: Up side 88° (typ.), Down side 88° (typ.)
Viewing angle with optimum grayscale (γ2.2): Normal axis (perpendicular)
Antiglare
3H (min.) [by JIS K5600]
At LCD panel center
72% (typ.) [against NTSC color space]
Ton+Toff (10%←→ 90%)
25 ms (typ.)
At IL= 50mA /One circuit
(270) cd/m2 (typ.)
Signal system
Power supply voltage
LVDS 1port (Receiver: Equivalent of THC63LVDF84B, THine Electronics Inc.)
[8-bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)]
LCD panel signal processing board: 3.3V
LED Backlight type:
Backlight
Power consumption
Replaceable part
Lamp holder set: Type No.:150LHS36
Recommended LED driver board (Option)
LED driver board: Type No.:150PW02F
Corresponding wiring harness: Type No. 150CBL02
At IL= 50mA /One circuit, Checkered flag pattern
10.2 W (typ.)
3
PRELIMINARY DATA SHEET DOD-PP-1265 (3rd edition)
5

5 Page





NL10276BC30-39 arduino
NL10276BC30-39
4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
0V
ON
3.0V
0.1ms < Tr < 80ms
OFF
2.5V 3.0V
20ms max.
ON
Toff > 200ms
Display signals*,
Function signals
Note2
0V
0.01ms < t < 50ms
VALID period
0.01ms < t < 50ms
* These signals should be measured at the terminal of 100Ω resistance.
Note1: If there is a voltage variation (voltage drop) at the rising edge of VCC below 3.0V, there is a
possibility that a product does not work due to a protection circuit.
Note2: Display signals (D0+/-, D1+/-, D2+/-, D3+/-, CLK+/-) and function signal (MSL) must be set
to Low or High impedance, except the VALID period (See above sequence diagram), in order
to avoid the circuitry damage.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. If a customer stops the
display and function signals, VCC also must be shut down.
4.4.2 LED driver board
Display signals,
Function signals
Note1
Note2
VALID period
LED backlight: ON
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.
PRELIMINARY DATA SHEET DOD-PP-1265 (3rd edition)
11

11 Page







PáginasTotal 29 Páginas
PDF Descargar[ Datasheet NL10276BC30-39.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
NL10276BC30-32DDisplay ModuleNEC
NEC
NL10276BC30-33DDisplay ModuleNEC
NEC
NL10276BC30-34BDLCD ModuleNLT
NLT
NL10276BC30-34DLCD ModuleNEC
NEC

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar