|
|
PDF NL8060BC31-47 Data sheet ( Hoja de datos )
| Número de pieza | NL8060BC31-47 | |
| Descripción | TFT COLOR LCD MODULE | |
| Fabricantes | NEC | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de NL8060BC31-47 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
TFT COLOR LCD MODULE
NL8060BC31-47
31cm (12.1 Type)
SVGA
LVDS interface (1port)
DATA SHEET
DOD-PP-0922 (1st edition)
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-0922 (1st edition)
Published date: February 2010 CP(N)
1
© NEC LCD Technologies, Ltd.
2010 All rights reserved.
1 page  
NL8060BC31-47
2. GENERAL SPECIFICATIONS
Display area
246.0 (H) × 184.5 (V) mm
Diagonal size of display 31cm (12.1 inches)
Drive system
a-Si TFT active matrix
Display color
16,777,216 colors (At 8-bit input, FRC terminal= High)
262,144 colors (At 6-bit input, FRC terminal= Low or Open)
Pixel
800 (H) × 600 (V) pixels
Pixel arrangement
RGB (Red dot, Green dot, Blue dot) vertical stripe
Dot pitch
0.1025 (H) × 0.3075 (V) mm
Pixel pitch
0.3075 (H) × 0.3075 (V) mm
Module size
280.0 (W) × 210.0 (H) × 9.1 (D) mm (typ.)
Weight
580 g (typ.)
Contrast ratio
900:1 (typ.)
Viewing angle
At the contrast ratio ≥10:1
• Horizontal: Right side 80° (typ.), Left side 80° (typ.)
• Vertical: Up side 80° (typ.), Down side 80° (typ.)
Designed viewing direction
At DPS= Low or Open: Normal scan
• Viewing direction without image reversal: Up side (12 o'clock)
• Viewing direction with contrast peak: Down side (6 o'clock)
• Viewing angle with optimum grayscale (γ≒ 2.2): Normal axis
(perpendicular)
Polarizer surface
Clear
Polarizer pencil-hardness 3H (min.) [by JIS K5400]
Color gamut
Response time
Luminance
Signal system
At LCD panel center
40% (typ.) [against NTSC color space]
Ton+Toff (10%←→ 90%)
18 ms (typ.)
At IL= 50mA/One circuit
450 cd/m2 (typ.)
LVDS 1port
(Receiver: THC63LVDF84B, THine Electronics Inc. or equivalent)
[8bit/6bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)]
Power supply voltage
LCD panel signal processing board: 3.3V
LED backlight type:
Backlight
Replaceable part
• Lamp holder set: Type No. 121LHS29
Recommended LED Driver board (Option)
• LED driver board :Type No. 121PW02F
Power consumption
At IL=50mA/One circuit, Checkered flag pattern
4.9 W (typ.)
DATA SHEET DOD-PP-0922 (1st edition)
5
5 Page 
4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
0V
ON
3.0V
10μs ≤ Tr < 50ms
Display signals*
Function signals
Note2
0V
0ms < t < 35ms
VALID period
NL8060BC31-47
OFF ON
0.3V
Toff ≥ 50ms
0ms < t < 35ms
* These signals should be measured at the terminal of 100Ω resistance.
Note1: In terms of voltage variation (voltage drop) while VCC rising edge is below 3.0V, a protection
circuit may work, and then this product may not work.
Note2: Display signals (D0+/-, D1+/-, D2+/-, D3+/- and CLK+/-) and function signals (DPS, FRC
and MSL) must be Low or High-impedance, exclude the VALID period (See above sequence
diagram), in order to avoid that internal circuits is damaged.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. If customer stops the
display and function signals, they should be cut VCC.
4.4.2 LED Driver board (Option)
Display signals,
Function signals
Note1
Note2
VALID period
LED backlight: ON
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.
DATA SHEET DOD-PP-0922 (1st edition)
11
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet NL8060BC31-47.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| NL8060BC31-41C | Display Module | NEC |
| NL8060BC31-41D | Display Module | NEC |
| NL8060BC31-42 | Display Module | NEC |
| NL8060BC31-42D | Display Module | NEC |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |