|
|
PDF dsPIC33EV64GM004 Data sheet ( Hoja de datos )
| Número de pieza | dsPIC33EV64GM004 | |
| Descripción | 16-Bit 5V Digital Signal Controllers | |
| Fabricantes | Microchip | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de dsPIC33EV64GM004 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
dsPIC33EVXXXGM00X/10X FAMILY
16-Bit, 5V Digital Signal Controllers with
PWM, SENT, Op Amps and Advanced Analog Features
Operating Conditions
• 4.5V to 5.5V, -40°C to +85°C, DC to 70 MIPS
• 4.5V to 5.5V, -40°C to +125°C, DC to 60 MIPS
• 4.5V to 5.5V, -40°C to +150°C, DC to 40 MIPS
Core: 16-Bit dsPIC33E CPU
• Code-Efficient (C and Assembly) Architecture
• 16-Bit Wide Data Path
• Two 40-Bit Wide Accumulators
• Single-Cycle (MAC/MPY) with Dual Data Fetch
• Single-Cycle, Mixed-Sign MUL plus Hardware
Divide
• 32-Bit Multiply Support
• Intermediate Security for Memory:
- Provides a Boot Flash Segment in addition to
the existing General Flash Segment
• Error Code Correction (ECC) for Flash
• Added Two Alternate Register Sets for Fast
Context Switching
Clock Management
• Internal, 15% Low-Power RC (LPRC) – 32 kHz
• Internal, 1% Fast RC (FRC) – 7.37 MHz
• Internal, 10% Backup RC (BFRC) – 7.37 MHz
• Programmable PLLs and Oscillator Clock Sources
• Fail-Safe Clock Monitor (FSCM)
• Additional FSCM Source (BFRC), Intended to
Provide a Clock Fail Switch Source for the
System Clock
• Independent Watchdog Timer (WDT)
• System Windowed Watchdog Timer (DMT)
• Fast Wake-up and Start-up
Power Management
• Low-Power Management modes (Sleep, Idle
and Doze)
• Power Consumption Minimized Executing
NOP String
• Integrated Power-on Reset (POR) and Brown-out
Reset (BOR)
• 0.5 mA/MHz Dynamic Current (typical)
• 50 µA at +25°C IPD Current (typical)
PWM
• Up to Six Pulse-Width Modulation (PWM) Outputs
(three generators)
• Primary Master Time Base Inputs allow
Time Base Synchronization from Internal/External
Sources
• Dead Time for Rising and Falling Edges
• 7.14 ns PWM Resolution
• PWM Support for:
- DC/DC, AC/DC, inverters, Power Factor
Correction (PFC) and lighting
- Brushless Direct Current (BLDC), Permanent
Magnet Synchronous Motor (PMSM),
AC Induction Motor (ACIM), Switched
Reluctance Motor (SRM)
- Programmable Fault inputs
- Flexible trigger configurations for
Analog-to-Digital conversion
- Supports PWM lock, PWM output chopping
and dynamic phase shifting
Advanced Analog Features
• ADC module:
- Configurable as 10-bit, 1.1 Msps with
four S&H or 12-bit, 500 ksps with one S&H
- Up to 36 analog inputs
• Flexible and Independent ADC Trigger Sources
• Up to Four Op Amp/Comparators with Direct
Connection to the ADC module:
- Additional dedicated comparator and
7-bit Digital-to-Analog Converter (DAC)
- Two comparator voltage reference outputs
- Programmable references with 128 voltage
points
- Programmable blanking and filtering
• Charge Time Measurement Unit (CTMU):
- Supports mTouch™ capacitive touch sensing
- Provides high-resolution time
measurement (1 ns)
- On-chip temperature measurement
- Temperature sensor diode
- Nine sources of edge input triggers (CTED1,
CTED2, OCPWM, TMR1, SYSCLK, OSCLK,
FRC, BFRC and LPRC)
2013-2014 Microchip Technology Inc.
DS70005144C-page 1
1 page  
dsPIC33EVXXXGM00X/10X FAMILY
Pin Diagrams (Continued)
28-Pin QFN-S(1,2,3,4)
PGED3/OA2IN-/AN2/C21N1-/SS1/RPI32/CTED2/RB0
PGEC3/OA1OUT/AN3/C1IN4-/C4IN2-/RPI33/CTED1/RB1
PGEC1/OA1IN+/AN4/C1IN3-/C1IN1+/C2IN3-/RPI34/RB2
PGED1/OA1IN-/AN5/C1IN1-/CTMUC/RP35/RB3
VSS
OSC1/CLKI/AN32/RPI18/RA2
OSC2/CLKO/RPI19/RA3
28 27 26 25 24 23 22
1 21
2 20
3 dsPIC33EV 64GM002/102 19
4 dsPIC33EV 128GM002/102 18
5 dsPIC33EV256GM002/102 17
6 16
7 15
8 9 10 11 12 13 14
RPI45/PWM1L2/CTPLS/RB13
RPI44/PWM1H2/RB12
RP43/PWM1L3/RB11
RP42/PWM1H3/RB10
VCAP
VSS
OA5IN-/AN27/C5IN1-/ASDA1/SDI1/RP41/RB9
Note 1:
2:
3:
4:
The RPn/RPIn pins can be used by any remappable peripheral with some limitation. See Section 11.5 “Peripheral
Pin Select (PPS)” for available peripherals and information on limitations.
Every I/O port pin (RAx-RGx) can be used as a Change Notification pin (CNAx-CNGx). See Section 11.0 “I/O
Ports” for more information.
If the op amp is selected when OPAEN (CMxCON<10>) = 1, the OAx input is used; otherwise, the ANx input is
used.
The metal pad at the bottom of the device is not connected to any pins and is recommended to be connected to
VSS externally.
2013-2014 Microchip Technology Inc.
DS70005144C-page 5
5 Page 
dsPIC33EVXXXGM00X/10X FAMILY
TO OUR VALUED CUSTOMERS
It is our intention to provide our valued customers with the best documentation possible to ensure successful use of your Microchip
products. To this end, we will continue to improve our publications to better suit your needs. Our publications will be refined and
enhanced as new volumes and updates are introduced.
If you have any questions or comments regarding this publication, please contact the Marketing Communications Department via
Most Current Data Sheet
To obtain the most up-to-date version of this data sheet, please register at our Worldwide Web site at:
http://www.microchip.com
You can determine the version of a data sheet by examining its literature number found on the bottom outside corner of any page.
The last character of the literature number is the version number, (e.g., DS30000000A is version A of document DS30000000).
Errata
An errata sheet, describing minor operational differences from the data sheet and recommended workarounds, may exist for current
devices. As device/documentation issues become known to us, we will publish an errata sheet. The errata will specify the revision
of silicon and revision of document to which it applies.
To determine if an errata sheet exists for a particular device, please check with one of the following:
• Microchip’s Worldwide Web site; http://www.microchip.com
• Your local Microchip sales office (see last page)
When contacting a sales office, please specify which device, revision of silicon and data sheet (include literature number) you are
using.
Customer Notification System
Register on our web site at www.microchip.com to receive the most current information on all of our products.
2013-2014 Microchip Technology Inc.
DS70005144C-page 11
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet dsPIC33EV64GM004.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| dsPIC33EV64GM002 | Flash Programming Specification | Microchip |
| dsPIC33EV64GM002 | 16-Bit 5V Digital Signal Controllers | Microchip |
| dsPIC33EV64GM004 | Flash Programming Specification | Microchip |
| dsPIC33EV64GM004 | 16-Bit 5V Digital Signal Controllers | Microchip |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |