dsPIC33EV64GM002 Datasheet PDF - Microchip
| Part Number | dsPIC33EV64GM002 | |
| Description | 16-Bit 5V Digital Signal Controllers | |
| Manufacturers | Microchip | |
| Logo |  |
|
|
There is a preview and dsPIC33EV64GM002 download ( pdf file ) link at the bottom of this page. Total 30 Pages | ||
Preview 1 page No Preview Available !
dsPIC33EVXXXGM00X/10X FAMILY
16-Bit, 5V Digital Signal Controllers with
PWM, SENT, Op Amps and Advanced Analog Features
Operating Conditions
• 4.5V to 5.5V, -40°C to +85°C, DC to 70 MIPS
• 4.5V to 5.5V, -40°C to +125°C, DC to 60 MIPS
• 4.5V to 5.5V, -40°C to +150°C, DC to 40 MIPS
Core: 16-Bit dsPIC33E CPU
• Code-Efficient (C and Assembly) Architecture
• 16-Bit Wide Data Path
• Two 40-Bit Wide Accumulators
• Single-Cycle (MAC/MPY) with Dual Data Fetch
• Single-Cycle, Mixed-Sign MUL plus Hardware
Divide
• 32-Bit Multiply Support
• Intermediate Security for Memory:
- Provides a Boot Flash Segment in addition to
the existing General Flash Segment
• Error Code Correction (ECC) for Flash
• Added Two Alternate Register Sets for Fast
Context Switching
Clock Management
• Internal, 15% Low-Power RC (LPRC) – 32 kHz
• Internal, 1% Fast RC (FRC) – 7.37 MHz
• Internal, 10% Backup RC (BFRC) – 7.37 MHz
• Programmable PLLs and Oscillator Clock Sources
• Fail-Safe Clock Monitor (FSCM)
• Additional FSCM Source (BFRC), Intended to
Provide a Clock Fail Switch Source for the
System Clock
• Independent Watchdog Timer (WDT)
• System Windowed Watchdog Timer (DMT)
• Fast Wake-up and Start-up
Power Management
• Low-Power Management modes (Sleep, Idle
and Doze)
• Power Consumption Minimized Executing
NOP String
• Integrated Power-on Reset (POR) and Brown-out
Reset (BOR)
• 0.5 mA/MHz Dynamic Current (typical)
• 50 µA at +25°C IPD Current (typical)
PWM
• Up to Six Pulse-Width Modulation (PWM) Outputs
(three generators)
• Primary Master Time Base Inputs allow
Time Base Synchronization from Internal/External
Sources
• Dead Time for Rising and Falling Edges
• 7.14 ns PWM Resolution
• PWM Support for:
- DC/DC, AC/DC, inverters, Power Factor
Correction (PFC) and lighting
- Brushless Direct Current (BLDC), Permanent
Magnet Synchronous Motor (PMSM),
AC Induction Motor (ACIM), Switched
Reluctance Motor (SRM)
- Programmable Fault inputs
- Flexible trigger configurations for
Analog-to-Digital conversion
- Supports PWM lock, PWM output chopping
and dynamic phase shifting
Advanced Analog Features
• ADC module:
- Configurable as 10-bit, 1.1 Msps with
four S&H or 12-bit, 500 ksps with one S&H
- Up to 36 analog inputs
• Flexible and Independent ADC Trigger Sources
• Up to Four Op Amp/Comparators with Direct
Connection to the ADC module:
- Additional dedicated comparator and
7-bit Digital-to-Analog Converter (DAC)
- Two comparator voltage reference outputs
- Programmable references with 128 voltage
points
- Programmable blanking and filtering
• Charge Time Measurement Unit (CTMU):
- Supports mTouch™ capacitive touch sensing
- Provides high-resolution time
measurement (1 ns)
- On-chip temperature measurement
- Temperature sensor diode
- Nine sources of edge input triggers (CTED1,
CTED2, OCPWM, TMR1, SYSCLK, OSCLK,
FRC, BFRC and LPRC)
2013-2014 Microchip Technology Inc.
DS70005144C-page 1
|
| |
 
dsPIC33EVXXXGM00X/10X FAMILY
Pin Diagrams (Continued)
28-Pin QFN-S(1,2,3,4)
PGED3/OA2IN-/AN2/C21N1-/SS1/RPI32/CTED2/RB0
PGEC3/OA1OUT/AN3/C1IN4-/C4IN2-/RPI33/CTED1/RB1
PGEC1/OA1IN+/AN4/C1IN3-/C1IN1+/C2IN3-/RPI34/RB2
PGED1/OA1IN-/AN5/C1IN1-/CTMUC/RP35/RB3
VSS
OSC1/CLKI/AN32/RPI18/RA2
OSC2/CLKO/RPI19/RA3
28 27 26 25 24 23 22
1 21
2 20
3 dsPIC33EV 64GM002/102 19
4 dsPIC33EV 128GM002/102 18
5 dsPIC33EV256GM002/102 17
6 16
7 15
8 9 10 11 12 13 14
RPI45/PWM1L2/CTPLS/RB13
RPI44/PWM1H2/RB12
RP43/PWM1L3/RB11
RP42/PWM1H3/RB10
VCAP
VSS
OA5IN-/AN27/C5IN1-/ASDA1/SDI1/RP41/RB9
Note 1:
2:
3:
4:
The RPn/RPIn pins can be used by any remappable peripheral with some limitation. See Section 11.5 “Peripheral
Pin Select (PPS)” for available peripherals and information on limitations.
Every I/O port pin (RAx-RGx) can be used as a Change Notification pin (CNAx-CNGx). See Section 11.0 “I/O
Ports” for more information.
If the op amp is selected when OPAEN (CMxCON<10>) = 1, the OAx input is used; otherwise, the ANx input is
used.
The metal pad at the bottom of the device is not connected to any pins and is recommended to be connected to
VSS externally.
2013-2014 Microchip Technology Inc.
DS70005144C-page 5
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for dsPIC33EV64GM002 electronic component. |
| Information | Total 30 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ dsPIC33EV64GM002.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| dsPIC33EV64GM002 | The function is Flash Programming Specification. Microchip | |
| dsPIC33EV64GM002 | The function is 16-Bit 5V Digital Signal Controllers. Microchip | |
| dsPIC33EV64GM004 | The function is Flash Programming Specification. Microchip | |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
dsPI
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||