DataSheet26.com

LF100ED PDF даташит

Спецификация LF100ED изготовлена ​​​​«MicroPowerDirect» и имеет функцию, называемую «Dual Output Ultra-Miniature 1W SMT DC/DC Converters».

Детали детали

Номер произв LF100ED
Описание Dual Output Ultra-Miniature 1W SMT DC/DC Converters
Производители MicroPowerDirect
логотип MicroPowerDirect логотип 

2 Pages
scroll

No Preview Available !

LF100ED Даташит, Описание, Даташиты
LF100ED Series
Lowest Cost, Dual Output
Ultra-Miniature 1W SMT
DC/DC Converters
Key Features:
1W Output Power
Ultra-Miniature SMT Case
UL Approved (File E245422)
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
3.3 VDC Input 3.0 3.3 3.6
Input Voltage Range
5 VDC Input 4.5 5.0 5.5
VDC
12 VDC Input 10.8 12.0 13.2
Dual Outputs
Reverse Polarity Input Current
1.0 A
Low 0.29” Profile
1,000 VDC Isolation
>3.5 MHour MTBF
3.3V, 5V, & 12V Inputs
LOWEST COST!
Input Filter
Output
Parameter
Output Voltage Accuracy
Output Voltage Balance
Line Regulation
Capacitor
Conditions
Min. Typ. Max.
±3.0
Balanced Loads
±1.0
For Vin Change of 1%
±1.2
Units
%
%
%
Load Regulation (Note 1)
See Model Selection Guide
Ripple & Noise (20 MHz) (Note 2)
50 75 mV P - P
Temperature Coefficient
±0.03 %/ºC
Output Short Circuit
Momentary (0.5 Sec.)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,000
VDC
Isolation Resistance
500 VDC 1,000
MΩ
Isolation Capacitance
100 kHz, 1V
70
pF
Switching Frequency
100 kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
ºC
Storage Temperature Range
-55
+125
ºC
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95 %
Physical
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Case Size
Case Material
Weight
Reliability Specifications
Parameter
0.60 x 0.29 x 0.24 Inches (15.24 x 7.5 x 6.0 mm)
Non-Conductive Black Plastic (UL94-V0)
0.05 Oz (1.5g)
Conditions
Min. Typ. Max. Units
T: (781) 344-8226
F: (781) 344-8481
W: www.micropowerdirect.com
MTBF
Safety Standards
Safety Approvals
Absolute Maximum Ratings
MIL HDBK 217F, 25ºC, Gnd Benign 3.5
UL 1950, EN 60950, IEC 60950
UL, cUL; File No. E245422
MHours
Parameter
Conditions
Min. Typ. Max. Units
3.3 VDC Input -0.7
7.0
Input Voltage Surge (1 Sec)
5 VDC Input -0.7
7.0 VDC
12 VDC Input -0.7
15.0
Lead Temperature
1.5 mm From Case For 10 Sec
260.0
ºC
Internal Power Dissipation
All Models
450 mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
http://www.Datasheet4U.com









No Preview Available !

LF100ED Даташит, Описание, Даташиты
Model Selection Guide
Model
Number
LF101ED
LF102ED
LF103ED
LF104ED
LF111ED
LF112ED
LF113ED
LF114ED
LF151ED
LF152ED
LF153ED
Input
Voltage (VDC)
Current (mA)
Nominal Range Full-Load No-Load
5
4.5 - 5.5
277
30
5
4.5 - 5.5
250
30
5
4.5 - 5.5
256
30
5
4.5 - 5.5
253
30
12 10.8 - 13.2 112
15
12 10.8 - 13.2 110
15
12 10.8 - 13.2 105
15
12 10.8 - 13.2 104
15
3.3 3.0 - 3.6 452
55
3.3 3.0 - 3.6 445
55
3.3 3.0 - 3.6 432
55
Voltage
(VDC)
±5.0
±9.0
±12.0
±15.0
±5.0
±9.0
±12.0
±15.0
±5.0
±12.0
±15.0
Output
Current
(mA, Max)
±100.0
±56.0
±42.0
±33.0
±100.0
±56.0
±42.0
±33.0
±100.0
±42.0
±33.0
Current
(mA, Min)
±10.0
±6.0
±5.0
±4.0
±10.0
±6.0
±5.0
±4.0
±10.0
±5.0
±4.0
Load
Regulation
(%, Max)
12.0
8.0
8.5
7.0
12.0
8.0
8.5
7.0
12.0
8.5
7.0
Notes:
1. Output load regulation is specified for a load change of 20% to 100%.
2. When measuring output ripple, it is recommended that an external 0.33 µF ce-
ramic capacitor be placed from the +Vout pin to the -Vout pin for single output
units and from each output to common for dual output units.
3. During operation, care must be taken not to exceed the specified input range
of the unit or to allow the output load to drop below the specified minimum
(10% of full load). Operating the unit under either of these conditions could
cause damage to the unit.
4. These converters are specified for operation without external components. How-
ever, in some applications the addition of input/output capacitors will enhance
stability and reduce output ripple. Recommended capacitor values are:
Derating Curve
Efficiency
(%, Typ)
72
75
78
79
74
76
78
79
67
68
70
Fuse Rating
Slow-Blow
(mA)
500
500
500
500
200
200
200
200
750
750
750
Vin
5 VDC
12 VDC
24 VDC
Input
Capacitor
4.7 µF
2.2 µF
1.0 µF
Vout
5 VDC
9 VDC
12 VDC
15 VDC
Output
Capacitor
4.7 µF
2.2 µF
1.0 µF
0.47 µF
For applications requiring very low output noise
levels, a simple LC filter should be effective.
5. It is recommended that a fuse be used on the
input of a power supply for protection. See the
Model Selection table above for the correct
rating.
Mechanical Dimensions
Pin Connections
Pin Description
Pin Description
1 -Vin
6 NC
2 +Vin
7 +Vout
3 NC
8 NC
4 Common 9 NC
5 -Vout
10 NC
NC = No Connection
Recommended Solder Profile
Board Layout
Notes:
All dimensions are typical in inches (mm)
Tolerance x.xx = ±0.01 (±0.25)
Pin 1 is marked by a “dot” or indentation on the unit
MicroPower Direct
www.micropowerdirect.com
292 Page Street Ste D Stoughton, MA 02072 TEL: (781) 344-8226 FAX: (781) 344-8481 E-Mail: [email protected]
http://www.Datasheet4U.com










Скачать PDF:

[ LF100ED.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
LF100EDDual Output Ultra-Miniature 1W SMT DC/DC ConvertersMicroPowerDirect
MicroPowerDirect

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск