DataSheet.es    


PDF MT6301 Data sheet ( Hoja de datos )

Número de pieza MT6301
Descripción Touch-Screen Controller
Fabricantes MediaTek 
Logotipo MediaTek Logotipo



Hay una vista previa y un enlace de descarga de MT6301 (archivo pdf) en la parte inferior de esta página.


Total 17 Páginas

No Preview Available ! MT6301 Hoja de datos, Descripción, Manual

MTK Confidential A (機密)
(宇陽MediaTek
6301 Touch-Screen Controller
聯發機Specifications洩漏
MediaTek Inc.
MTK CONFIDENTIAL
NO DISCLOSUREConfidential Information
This document is issued by MediaTek Inc. in confidence and is not to be reproduced in
whole or in part without the prior written permission of MediaTek Inc. and is to be used
only for the purpose for which it is submitted and is not to be released in whole or in part
宇陽)without the prior written permission of MediaTek Inc.
Rev. 1.1, Date: Feb., 21, 2006
Free Datasheet http://www.datasheetlist.com/

1 page




MT6301 pdf
6301 TSC Specification
Commercial Confidential
MTK Confidential A (機密)
MediaTek Inc.
3 Functional Description
3.1 General
The MT6301 is a 12-bit single supply successive approximation ADC. The architecture is a low-power
comparator with capacitive DAC including sample-and-hold function. The single supply ranges from 2.6V to
5.5V. The throughput rate could be up to 125kSPS with 2MHz clock.
There are two selected modes for the sources of positive and negative references of ADC. One is the
(宇陽single-ended reference mode. In this mode, the references are from Vref pin and GND pin. The other is
differential reference mode. In this mode, the references are sampled from X+/X- or Y+/Y- depending on
register settings, and the ADC performs ratio-metric conversion which avoids frequently system calibration
that happened in single-ended reference mode. With the proprietary power-saving technique, the ON time
of the driver switches are the same in the both mode. Thus saving the power dissipation greatly when
operates in differential reference mode.
The 2 auxiliary inputs facilitate system applications and saving the system cost. It could only be single-
ended reference mode when either of the 2 auxiliary inputs is selected.
The pen interrupt function clearly indicates the touch/un-touch status of the screen. It is a continuous
function with no ambiguity that facilitates the software programming. The /PENIRQ output is free from the
discrete pull-up resistor.
The register settings are accomplished by the serial data interface, and also the outputting of the
conversion result.
Figure.1 shows the block diagram of MT6301.
聯發機密不得洩漏Vdd Vref
PENIRQ
PEN
INTERRUPT
MTKX+
X-
CONFS/H IDENTIAL
Y+
Y- +REF
NO DISCLOSURE4-channel
Multiplexer
CONVERTER
-REF
IN3
IN4
S/H
宇陽)DIGITAL INTERFACE
Vdd GND
CS
DCLK
DIN
BUSY
Figure 1 MT6301 Block Diagram
DOUT
Confidential Information
Revision 1.1 – Feb. 21, 2006
© 2006 MediaTek Inc.
5 / 17
The information contained in this document cannot be distributed or reproduced without the prior written permission of MediaTek Inc.
Free Datasheet http://www.datasheetlist.com/

5 Page





MT6301 arduino
6301 TSC Specification
Commercial Confidential
MTK Confidential A (機密)
MediaTek Inc.
4 Specifications
4.1 Absolute maximum over operating free-air temperature range
Table 5 Absolute Maximum Ratings
(宇陽Parameter
Conditions
Min Typ
Max
Free-air temperature range
-40 85
Storage temperature range
-65 150
ESD robustness
8000
Units
°C
°C
V
4.2 Operating conditions
Table 6 Operation Condition
Parameter
Conditions
Min Typ Max Units
Operating temperature range
-40 85 °C
聯發機密不得洩漏4.3 Recommended operating specifications
Table 7 General Specifications
(TA=-40oC to 85oC, Vdd=2.8V, Vref=2.8V, fsample=125KHz, fsample=2MHz, 12-bit mode, digital inputs = GND or Vdd.
Typical values are at 25oC, unless otherwise noted.)
Items
DC Accuracy
MTK CONFIDENTIALResolution
Specification
12
Unit
Bits
Notes
No Missing Codes
11 Bits min
Offset Errors
+/-6 LSB max
Gain Errors
+/-4 LSB max
Switch Drivers
On-Resistance
X+/Y+
NO DISCLOSUREX-/Y-
5 Ohm typ
5 Ohm typ
Analog Input
Input Voltage Ranges
Input Capacitance
0~Vref
25
V
pF max
Reference Input
Range
Input Impedance
Logic Input/Output
VOH
VOL
VIH
VIL
Conversion Rate
Conversion Time
Sampling Time
Throughput Rate
1~Vdd
5
V
GOhm typ
Vdd-0.2
Vmin
0.4 Vmax
宇陽)Vdd*0.7
Vdd+0.3
-0.3
0.8
12
Vmin
Vmax
Vmin
Vmax
DCLK Cycles max
3 DCLK Cycles min
125 KSPS max
Confidential Information
Revision 1.1 – Feb. 21, 2006
© 2006 MediaTek Inc.
11 / 17
The information contained in this document cannot be distributed or reproduced without the prior written permission of MediaTek Inc.
Free Datasheet http://www.datasheetlist.com/

11 Page







PáginasTotal 17 Páginas
PDF Descargar[ Datasheet MT6301.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
MT6301Touch-Screen ControllerMediaTek
MediaTek
MT6302Dual SIM Card ControllerMediaTek
MediaTek
MT6305BGSM Power Management SystemMediaTek
MediaTek

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar