DataSheet26.com

UPC177GR-9LG PDF даташит

Спецификация UPC177GR-9LG изготовлена ​​​​«NEC» и имеет функцию, называемую «SINGLE POWER SUPPLY QUAD COMPARATORS».

Детали детали

Номер произв UPC177GR-9LG
Описание SINGLE POWER SUPPLY QUAD COMPARATORS
Производители NEC
логотип NEC логотип 

10 Pages
scroll

No Preview Available !

UPC177GR-9LG Даташит, Описание, Даташиты
DATA SHEET
BIPOLAR ANALOG INTEGRATED CIRCUIT
μ PC177GR-9LG, μ PC339GR-9LG
SINGLE POWER SUPPLY QUAD COMPARATORS
<R> DESCRIPTION
The μ PC177GR-9LG, μ PC339GR-9LG are quad comparators which are designed to operate for a single power
supply. It includes features of low-voltage operation, a common-mode input voltage that range from V(GND) level,
an open collector output, and low current consumption. Furthermore, these products can operate on a split power
supply and be used for an extensive comparison of various voltages.
The μ PC177GR-9LG which expands temperature type is suited for wide operating ambient temperature use, and
μ PC339GR-9LG is used for general purposes.
A DC parameter selection that is compatible to comparators is also available.
μ PC277GR-9LG, μ PC277MP-KAA, μ PC393GR-9LG which are dual types with the same circuit configuration are
also available as series of comparators.
<R> FEATURES
• Input Offset Voltage ±1 mV (TYP.)
• A wired OR is possible as the open collector is output.
• Input Bias Current
20 nA (TYP.)
• A low voltage operation is possible. V+ V: +2 to +32 V
• Voltage Gain
200000 (TYP.)
• Pulse Response Time 1.6 μs (TYP.)
• Output Sink Current 16 mA (TYP.)
• Small Package (The mounting area is reduced to half comparedhttp://www.DataSheet4U.net/ to the conventional 14-pin plastic SOP (1.27 mm
pitch))
<R> ORDERING INFORMATION
Part Number
μ PC177GR-9LG-E1-A Note
Selected Grade
Standard
μ PC177GR-9LG-E2-A Note
Standard
μ PC177GR(5)-9LG-E1-A Note
μ PC177GR(5)-9LG-E2-A Note
μ PC339GR-9LG-E1-A Note
DC
parameter selection
DC
parameter selection
Standard
μ PC339GR-9LG-E2-A Note
Standard
μ PC339GR(5)-9LG-E1-A Note
μ PC339GR(5)-9LG-E2-A Note
DC
parameter selection
DC
parameter selection
Package
14-pin plastic TSSOP (5.72 mm(225))
14-pin plastic TSSOP (5.72 mm(225))
14-pin plastic TSSOP (5.72 mm(225))
14-pin plastic TSSOP (5.72 mm(225))
14-pin plastic TSSOP (5.72 mm(225))
14-pin plastic TSSOP (5.72 mm(225))
14-pin plastic TSSOP (5.72 mm(225))
14-pin plastic TSSOP (5.72 mm(225))
Package Type
16 mm wide embossed taping
Pin 1 on draw-out side
16 mm wide embossed taping
Pin 1 at take-up side
16 mm wide embossed taping
Pin 1 on draw-out side
16 mm wide embossed taping
Pin 1 at take-up side
16 mm wide embossed taping
Pin 1 on draw-out side
16 mm wide embossed taping
Pin 1 at take-up side
16 mm wide embossed taping
Pin 1 on draw-out side
16 mm wide embossed taping
Pin 1 at take-up side
Note Pb-free (This product does not contain Pb in the external electrode and other parts.)
The information in this document is subject to change without notice. Before using this document, please
confirm that this is the latest version.
Not all products and/or types are available in every country. Please check with an NEC Electronics
sales representative for availability and additional information.
Document No. G17933EJ3V0DS00 (3rd edition)
Date Published December 2007 NS
Printed in Japan
The mark <R> shows major revised points.
2006, 2007
The revised points can be easily searched by copying an "<R>" in the PDF file and specifying it in the "Find what:" field.
datasheet pdf - http://www.DataSheet4U.net/









No Preview Available !

UPC177GR-9LG Даташит, Описание, Даташиты
μ PC177GR-9LG, μ PC339GR-9LG
EQUIVALENT CIRCUIT (1/4 Circuit)
<R> PIN CONFIGURATION (Marking side)
+ Q2
IN Q1
II
Q5
100 μA
V+
100 μA
Q3
Q4
Q6
Q8
Q7
OUT
OUT2
OUT1
V+
II1
IN1
II2
IN2
1
2
3
4
5
6
7
1+
2+
4+
3+
14 OUT3
13 OUT4
12 V
11 IN4
10 II4
9 IN3
8 II3
V
<R> ABSOLUTE MAXIMUM RATINGS (TA = 25°C)
Parameter
Voltage between V+ and VNote1
Symbol
V+ V
μ PC177GR-9LG,
μ PC339GR-9LG,
μ PC177GR(5)-9LG
μ PC339GR(5)-9LG
0.3 to +36
Unit
V
Differential Input Voltage
Input Voltage Note2
Output applied Voltage Note3
Total Power Dissipation Note4
Output Short Circuit Duration (vs. GND) Note5
VID
VI
VO
PT
tS
±36
V0.3 to V+ 36
V0.3 to V+ 36
550
Indefinite
V
V
V
mW
s
Operating Ambient Temperature
Storage Temperature
TA
Tstg
http://www.DataSheet4U.net/
40 to +125
55 to +150
40 to +85
55 to +125
°C
°C
Note1. Note that reverse connections of the power supply may damage ICs.
2. The input voltage is allowed to input without damage or destruction independent of the magnitude of V+. Either
input signal is not allowed to go negative by more than 0.3 V. In addition, the input voltage that operates
normally as a comparator is within the Common Mode Input Voltage range of an electrical characteristic.
3. A range where input voltage can be applied to an output pin externally with no deterioration or damage to the
feature (characteristic). The input voltage can be applied regardless of the electric supply voltage. This
specification which includes the transition state such as electric power ON/OFF must be kept.
4. This is the value of when the glass epoxy substrate (size: 100 mm x 100 mm, thickness: 1 mm, 15% of the
substrate area where only one side is copper foiled is filling wired) is mounted.
Note that restrictions will be made to the following conditions for each product, and the derating ratio
depending on the operating ambient temperature.
μ PC177GR-9LG: Derate at 7.0 mW/°C when TA > 71°C.
(Junction ambient thermal resistance Rth(J-A) = 144°C/W)
μ PC339GR-9LG: Derate at 7.0 mW/°C when TA > 46°C.
(Junction ambient thermal resistance Rth(J-A) = 144°C/W)
5. Short circuits from the output to V+ can cause destruction. Pay careful attention to the total power dissipation
not to exceed the absolute maximum ratings, Note 4.
2 Data Sheet G17933EJ3V0DS
datasheet pdf - http://www.DataSheet4U.net/









No Preview Available !

UPC177GR-9LG Даташит, Описание, Даташиты
μ PC177GR-9LG, μ PC339GR-9LG
RECOMMENDED OPERATING CONDITIONS
Parameter
Power Supply Voltage (Split)
Power Supply Voltage (V= GND)
Symbol
V±
V+
MIN.
±1
+2
TYP.
MAX.
±16
+32
Unit
V
V
<R> ELECTRICAL CHARACTERISTICS
μ PC177GR-9LG, μ PC339GR-9LG (TA = 25°C, V+ = +5 V, V= GND)
Parameter
Symbol
Conditions
Input Offset Voltage
VIO VO = 1.4 V, VREF = 1.4 V, RS = 0 Ω
Input Offset Current
Input Bias Current Note1
IIO VO = 1.4 V
IB VO = 1.4 V
Voltage Gain
Circuit Current Note2
AV RL = 15 kΩ
ICC RL = , IO = 0 A
Common Mode lnput Voltage Range VICM
Output Saturation Voltage
Output Sink Current
VOL
IO SINK
VIN () = +1 V, VIN (+) = 0 V, IO SINK = 4 mA
VIN () = +1 V, VIN (+) = 0 V, VO 1.5 V
Output Leakage Current
Pulse Response Time Note3
IO LEAK
VIN (+) = +1 V, VIN () = 0 V, VO = 5 V
RL = 5.1 kΩ, VRL = 5 V,
MIN.
0
6
TYP.
±1
±5
20
200000
1.1
0.2
16
0.1
1.6
MAX.
±5
±50
250
2
V+ 1.5
0.4
Unit
mV
nA
nA
mA
V
V
mA
nA
μs
μ PC177GR(5)-9LG, μ PC339GR(5)-9LG (TA = 25°C, V+ = +5 V, V= GND)
Parameter
Symbol
Conditions
MIN.
TYP.
MAX.
Unit
Input Offset Voltage
VIO VO = 1.4 V, VREF = 1.4 V, RS = 0 Ω
±1 ±2.5 mV
Input Offset Current
Input Bias Current Note1
IIO
IB
VO = 1.4 V
VO = 1.4 V
http://www.DataSheet4U.net/
±5 ±50 nA
20 60 nA
Voltage Gain
Circuit Current Note2
Common Mode lnput Voltage Range
AV
ICC
VICM
RL = 15 kΩ
RL = , IO = 0 A
200000
1.1 1.2 mA
0
V+ 1.4
V
Output Saturation Voltage
Output Sink Current
Output Leakage Current
Pulse Response Time Note3
VOL1
VOL2
IO SINK
IO LEAK
VIN () = +1 V, VIN (+) = 0 V, IO SINK = 4 mA
VIN () = +1 V, VIN (+) = 0 V, IO SINK = 10 mA
VIN () = +1 V, VIN (+) = 0 V, VO 1.5 V
VIN (+) = +1 V, VIN () = 0 V, VO = 5 V
RL = 5.1 kΩ, VRL = 5 V,
10
0.2 V
1.5 V
16 mA
0.1 100 nA
1.6 μs
Notes1. The input bias current flows in the direction where the IC flows out because the first stage is configured with a
PNP transistor.
In addition, the value of this item is a value of when the differential amplified circuit of the input stage is
balanced. When the comparator is active, then twice the amount of current will flow to a pin with low
potential.
2. This is a current that flows in the internal circuit. This current will flow irrespective of the channel used.
3. This is the value when input oscillation is 100 mV and the over drive is 5 mV.
If the amount of over drive is increased then the response time can be cut down.
Data Sheet G17933EJ3V0DS
3
datasheet pdf - http://www.DataSheet4U.net/










Скачать PDF:

[ UPC177GR-9LG.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
UPC177GR-9LGSINGLE POWER SUPPLY QUAD COMPARATORSNEC
NEC

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск