|
|
Número de pieza | M150XN05-V6 | |
Descripción | LCD MODULE | |
Fabricantes | AUO | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de M150XN05-V6 (archivo pdf) en la parte inferior de esta página. Total 24 Páginas | ||
No Preview Available ! Spec.No.DDPM-M150XN05-0.5
Version: 6
Total pages: 24
Date: 2003-October-13
AU OPTRONICS CORPORATION
Product Specifications
15.0” XGA Color TFT-LCD Module
Model Name: M150XN05
V.6
Approved by
Prepared by
www.DataSheet.co.kr
IDBU Marketing Division / AU Optronics Croporation
Customer
Checked & Approved by
(C) Copyright AU Optronics, Inc.
Sep. 2002 All Rights Reserved.
No Reproduction and Redistribution Allowed.
M150XN05-6 Ver0.5
1/25
Datasheetpdf-http://www.DataSheet4U.net/
1 page 1.0 Handling Precautions
1) Since the upper polarizer can be easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth when
handling.
7) Do not open or modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a Module has to be put back into the packing container slot after once it was taken out from the
container, do not press the center of the CCFL Reflector edge. Instead, press at the far ends of the CCFL
Reflector edge softly. Otherwise the TFT Module may be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the Interface
Connector of the TFT Module.
11) After installation of the TFT Module into an enclosure (LCD monitor housing, for example), do not twist nor
bend the TFT Module even momentarily. At designing the enclosure, it should be taken into consideration
that no bending/twisting forces are applied to the TFT Module from outside. Otherwise the TFT Module
may be damaged.
12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please follow local ordinances or
regulations for disposal.
13) Small amount of materials not reaching flammability grade is used in the LCD module. The LCD module should
be supplied by power complied with requirements of Limited Power Source (2.11, IEC60950 or UL1950), or be
complied exemption.
14) The LCD module is designed for CCFL to be supplied by Limited Current Circuit (2.4, IEC60950 or UL1950). Do
not connect the CCFL in Hazardous Voltage Circuit.
www.DataSheet.co.kr
(C) Copyright AU Optronics, Inc.
Sep. 2002 All Rights Reserved.
No Reproduction and Redistribution Allowed.
M150XN05-6 Ver0.5
5/25
Datasheet pdf - http://www.DataSheet4U.net/
5 Page 4.0 Optical Characteristics
The optical characteristics are measured under stable conditions at 25 ℃ (Room Temperature):
Item
Viewing Angle
CR: Contrast Ratio
Contrast ratio
Response Time( Note 1)
Color / Chromaticity
Coordinates (CIE)
Color Coordinates (CIE) White
Brightness Uniformity
White Luminance at CCFL 8.0mA
White Luminance at CCFL 6.5mA
Crosstalk ( in 60Hz)
Unit Conditions
Horizontal (Right)
[degree] CR = 10 (Left)
[degree] Horizontal (Right)
CR =5
Vertical
(Left)
(Upper)
[degree] CR = 10 (Lower)
[degree] Vertical (Upper)
CR = 5 (Lower)
[msec]
[msec]
[msec]
Normal Direction
Raising Time Ton
( 10%-90% )
Falling Time Toff
( 90%-10% )
Raising + Falling
Red x
Red y
Green x
Green y
Blue x
www.DataSheet.co.kr
Blue y
White x
White y
[%]
[cd/m2]
[%]
Min.
50
50
60
60
30
50
45
65
300
-
-
-
0.587
0.317
0.260
0.563
0.118
0.070
0.283
0.299
75
200
170
-
Typ.
60
60
75
75
40
60
50
75
400
4
12
16
0.617
0.347
0.290
0.593
0.148
0.100
0.313
0.329
80
250
200
-
Max.
-
-
-
6
17
23
0.647
0.377
0.320
0.623
0.178
0.130
0.343
0.359
-
-
-
1.2
Note 1: Definition of Response time:
The output signals of photodetector are measured when the input signals are changed from “ Black” to
“ White” (falling time), and from “White” to “ Black” (rising time), respectively. The response time interval
between the 10% and 90% of amplitudes. Refer to figure as below.
TrR
%
TrD
Optical
Response
100
90
10 white
0
black
white
(C) Copyright AU Optronics, Inc.
Sep. 2002 All Rights Reserved.
No Reproduction and Redistribution Allowed.
M150XN05-6 Ver0.5
11/25
Datasheet pdf - http://www.DataSheet4U.net/
11 Page |
Páginas | Total 24 Páginas | |
PDF Descargar | [ Datasheet M150XN05-V6.PDF ] |
Número de pieza | Descripción | Fabricantes |
M150XN05-V1 | LCD MODULE | AUO |
M150XN05-V5 | XGA Color TFT-LCD Module | AUO |
M150XN05-V6 | LCD MODULE | AUO |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |