|
|
PDF 73S8014RN Data sheet ( Hoja de datos )
| Número de pieza | 73S8014RN | |
| Descripción | Smart Card Interface | |
| Fabricantes | Teridian Semiconductor | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de 73S8014RN (archivo pdf) en la parte inferior de esta página. Total 28 Páginas | ||
|
No Preview Available !
Simplifying System Integration™
www.DataSheet4U.com
73S8014RN
Smart Card Interface
DATA SHEET
December 2008
DESCRIPTION
The Teridian 73S8014RN is a single smart card (ICC) interface
circuit, firmware compatible with 8024-type devices for
configurations where only asynchronous cards must be
supported. It is derived from the 73S8024RN industry-
standard electrical interface. The 73S8014RN has been
optimized to match most of the typical Set-Top Box / A/V
Conditional Access applications. Optimization essentially
involved a smaller pin-count and support for single I/O.
The 73S8014RN interfaces with the host processor through the
same bus (digital I/Os) as the 73S8024RN, which is compatible
with any other 8024-type IC. As a result, the 73S8014RN is a
very attractive cost-reduction path from traditional 8024
ICs.
The 73S8014RN has been designed to provide full electrical
compliance with ISO 7816-3, EMV 4.0 and NDS specifications.
Interfacing with the system controller is done through a control
bus, composed of digital inputs to control the interface, and
one interrupt output to inform the system controller of the card
presence and faults.
The card clock can be generated by an on-chip oscillator using
an external crystal or by connection to an externally supplied
clock signal. In addition, the clock divider provides divisor
values of divide by 1, 2, 4 and 6 that are compatible with NDS
requirements.
The 73S8014RN incorporates an ISO 7816-3
activation/deactivation sequencer that controls the card
signals. Level-shifters drive the card signals with the selected
card voltage (3V or 5V), coming from an internal Low Drop-Out
(LDO) voltage regulator. This LDO regulator is powered by a
dedicated power supply input VPC. Digital circuitry is powered
separately by a digital power supply VDD. With its embedded
LDO regulator, the 73S8014RN is a cost-effective solution for
any application where a 5V (typically -5% +10%) power supply
is available.
Emergency card deactivation is initiated upon card extraction
or upon any fault detected by the protection circuitry. The fault
can be a card over-current, VCC undervoltage or power supply
fault (VDD). The card over-current circuitry is a true current
detection function, as opposed to VCC voltage drop detection,
as usually implemented in non-Teridian 8024 interface ICs.
The VDD voltage fault has a threshold voltage that can be
adjusted with an external resistor network. It allows automated
card deactivation at a customized VDD voltage threshold value.
It can be used, for instance, to match the system controller
operating voltage range.
APPLICATIONS
• Set-Top Box Conditional Access and Pay-per-View
• General purpose smart card readers
ADVANTAGES
• NDS compliant
• All NDS frequency divider rates of 4.5, 6.75 and
13.5MHz are supported from a 27MHz clock source
• Same advantages as the Teridian 73S80xxR family:
Card VCC generated by an LDO regulator
Very low power dissipation (saves up to 1/2W)
Fewer external components are required
Better noise performance
• True card over-current detection
• Firmware compatibility with all 8024 ICs
• Small format 20SO package
FEATURES
• Card Interface:
Complies with ISO 7816-3, EMV 4.0 and NDS
73S8014RN device supports 3V / 5V cards up to 65mA
ISO 7816-3 Activation / Deactivation sequencer
Automated deactivation upon hardware fault (i.e. upon
drop on VDD power supply or card overcurrent)
The VDD voltage supervisor threshold value (fault) can
be externally adjusted
Over-current detection 130mA max
Card CLK clock frequency up to 20MHz
• System Controller Interface:
3 Digital inputs control the card activation / deactivation,
card reset and card voltage
2 Digital inputs control the card clock frequency
1 Digital output, interrupt to the system controller,
reports to the host the card presence and faults
Crystal oscillator or host clock, up to 27MHz
• Regulator Power Supply:
4.75V to 5.5V (EMV 4.0)
4.85V to 5.5V (NDS)
• Digital Interfacing: 2.7V to 5.5V
• 6kV ESD protection on the card interface
• Package: SO 20-pin
• RoHS compliant (6/6) lead-free package
Rev. 1.0
© 2008 Teridian Semiconductor Corporation
1
1 page  
DS_8014RN_014
1 Pinout
The 73S8014RN is supplied as 20-pin SO package.
OFF
RSTIN
I/OUC
VPC
CLKDIV2
CMDVCC
5V/#V
GND
XTALIN
XTALOUT
1 20
2 19
3 18
4 17
5 16
73S8014RN
6 15
7 14
8 13
9 12
10 11
Figure 2: 73S8014RN 20-SOP Pin Out
www.DataSheet4U.com
73S8014RN Data Sheet
CLKDIV1
PRES
VCC
CLK
GND
RST
I/O
VDD
VDDF_ADJ
TEST
Rev. 1.0
5
5 Page 
DS_8014RN_014
www.DataSheet4U.com
73S8014RN Data Sheet
Symbol
Parameter
Condition
Reset and Clock for Card Interface, RST, CLK
VOH Output level, high
IOH =-200μA
VOL Output level, low
IOL=200μA, VCC = 5V
IOL=200μA, VCC = 3V
VINACT
IRST_LIM
ICLK_LIM
CLKSR3V
CLKSR5V
Output voltage when
outside of session
Output current limit, RST
Output current limit, CLK
CLK slew rate
CLK slew rate
tR, tF
Output rise time, fall time
IOL = 0
IOL = 1mA
<
Vcc = 5V
CL = 35pF for CLK,
10% to 90%
CL = 200pF for RST,
10% to 90%
δ Duty cycle for CLK
CL =35pF,
FCLK ≤ 20MHz
CL =35pF
Min
0.9 VCC
0
0
0.3
0.5
45
Nom
Max
VCC
0.45
0.2
0.1
0.3
30
70
8
100
55
Unit
V
V
V
V
V
mA
mA
V/ns
V/ns
ns
ns
%
2.5 Characteristics: Digital Signals
Table 6 lists the 73S8014RN digital signals characteristics.
Table 6: Digital Signals Characteristics
Symbol
Parameter
Condition
Digital I/O Except for XTALIN and XTALOUT
VIL Input Low Voltage
VIH Input High Voltage
VOL Output Low Voltage
IOL = 2mA
VOH
ROUT
|IIL1|
|IIL2|
Output High Voltage
Pull-up resistor, OFF
Input Leakage Current
Input Leakage Current
IOH = -1mA
GND < VIN < VDD
GND < VIN < VDD
CLKDIV2 only
Min
-0.3
1.8
VDD - 0.45
16
-5
-15
Nom
20
Max
0.8
VDD + 0.3
0.45
24
5
15
Unit
V
V
V
V
kΩ
μA
μA
Rev. 1.0
11
11 Page | ||
| Páginas | Total 28 Páginas | |
| PDF Descargar | [ Datasheet 73S8014RN.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| 73S8014R | Smart Card Interface | Teridian Semiconductor |
| 73S8014RN | Smart Card Interface | Teridian Semiconductor |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |