|
MX25L1005 PDF даташит
| Спецификация MX25L1005 изготовлена «Macronix International» и имеет функцию, называемую «1M-BIT [x 1] CMOS SERIAL FLASH». |
|
|
Детали детали
| Номер произв | MX25L1005 |
| Описание | 1M-BIT [x 1] CMOS SERIAL FLASH |
| Производители | Macronix International |
| логотип |  |
30 Pages
No Preview Available ! |
MX25L1005
MX25L1005
DATASHEET
The MX25L1005 product family is not recommended for new designs. The MX25L1005C
family is the recommended replacement. Please refer to MX25L1005C datasheet for
full specifications and ordering information, or contact your local sales representative for
additional support.
P/N: PM1238
REV. 2.0, APR. 15, 2009
1
No Preview Available ! |
MX25L1005
1M-BIT [x 1] CMOS SERIAL FLASH
The MX25L1005 product family is not recommended for new designs. The MX25L1005C
family is the recommended replacement. Please refer to MX25L1005C datasheet for
full specifications and ordering information, or contact your local sales representative for
additional support.
FEATURES
GENERAL
• Serial Peripheral Interface (SPI) compatible -- Mode 0 and Mode 3
• 1,048,576 x 1 bit structure
• 32 Equal Sectors with 4K byte each
- Any Sector can be erased individually
• 2 Equal Blocks with 64K byte each
- Any Block can be erased individually
• Single Power Supply Operation
- 2.7 to 3.6 volt for read, erase, and program operations
• Latch-up protected to 100mA from -1V to Vcc +1V
PERFORMANCE
• High Performance
- Fast access time: 85MHz serial clock (15pF + 1TTL Load) and 66MHz serial clock (30pF + 1TTL Load)
- Fast program time: 1.4ms(typ.) and 5ms(max.)/page (256-byte per page)
- Fast erase time: 60ms(typ.) and 120ms(max.)/sector (4K-byte per sector) ; 1s(typ.) and 2s(max.)/block (64K-byte
per block)
• Low Power Consumption
- Low active read current: 12mA(max.) at 85MHz, 8mA(max.) at 66MHz and 4mA(max.) at 33MHz
- Low active programming current: 15mA (max.)
- Low active erase current: 15mA (max.)
- Low standby current: 10uA (max.)
- Deep power-down mode 1uA (typical)
• Minimum 100,000 erase/program cycles
SOFTWARE FEATURES
• Input Data Format
- 1-byte Command code
• Block Lock protection
- The BP0~BP1 status bit defines the size of the area to be software protected against Program and Erase
instructions.
• Auto Erase and Auto Program Algorithm
- Automatically erases and verifies data at selected sector
- Automatically programs and verifies data at selected page by an internal algorithm that automatically times the
program pulse widths (Any page to be programed should have page in the erased state first)
• Status Register Feature
P/N: PM1238
REV. 2.0, APR. 15, 2009
2
No Preview Available ! |
• Electronic Identification
- JEDEC 2-byte Device ID
- RES command, 1-byte Device ID
HARDWARE FEATURES
• SCLK Input
- Serial clock input
• SI Input
- Serial Data Input
• SO Output
- Serial Data Output
• WP# pin
- Hardware write protection
• HOLD# pin
- pause the chip without diselecting the chip
• PACKAGE
- 8-pin SOP (150mil)
- 8-land USON (2x3x0.6mm)
- All Pb-free devices are RoHS Compliant
MX25L1005
GENERAL DESCRIPTION
MX25L1005 is a CMOS 1,048,576 bit serial Flash memory, which is configured as 131,072 x 8 internally.The
MX25L1005 feature a serial peripheral interface and software protocol allowing operation on a simple 3-wire bus.
The three bus signals are a clock input (SCLK), a serial data input (SI), and a serial data output (SO). SPI access to
the device is enabled by CS# input.
The MX25L1005 provide sequential read operation on whole chip.
After program/erase command is issued, auto program/ erase algorithms which program/ erase and verify the speci-
fied page or sector/block locations will be executed. Program command is executed on page (256 bytes) basis, and
erase command is executes on chip or sector(4K-bytes) or block(64K-bytes).
To provide user with ease of interface, a status register is included to indicate the status of the chip. The status read
command can be issued to detect completion status of a program or erase operation via WIP bit.
When the device is not in operation and CS# is high, it is put in standby mode and draws less than 10uA DC cur-
rent.
The MX25L1005 utilize MXIC's proprietary memory cell, which reliably stores memory contents even after 100,000
program and erase cycles.
P/N: PM1238
REV. 2.0, APR. 15, 2009
3
Скачать PDF:
[ MX25L1005.PDF Даташит ]
| Номер в каталоге | Описание | Производители |
| MX25L1005 | 1M-BIT [x 1] CMOS SERIAL FLASH | Macronix International |
| MX25L1006E | CMOS 1Mk-bit serial Flash memory |  MACRONIX |
| Номер в каталоге | Описание | Производители |
| TL431 | 100 мА, регулируемый прецизионный шунтирующий регулятор |
 Unisonic Technologies |
| IRF840 | 8 А, 500 В, N-канальный МОП-транзистор |
 Vishay |
| LM317 | Линейный стабилизатор напряжения, 1,5 А |
 STMicroelectronics |
|
DataSheet26.com | 2020 | Контакты | Поиск |