|
|
Número de pieza | T-51638D084J-FW-A-AC | |
Descripción | LCD_Module | |
Fabricantes | OPTREX | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de T-51638D084J-FW-A-AC (archivo pdf) en la parte inferior de esta página. Total 17 Páginas | ||
No Preview Available ! .comLCD Module Technical Specification
heet4UType No. T-51638D084J-FW-A-AC
First Edition
Nov 15, 2004
Final Revision
******
www.DataS Approved by (Quality Assurance Division)
Checked by (ACI Engineering Division)
mM.Noguchi
oPrepared by (ACI Engineering Division)
.cNo. Item
t4U-- CONTENTS
1 APPLICATION
e2 OVERVIEW
e3 ABSOLUTE MAXIMUM RATINGS
h4 ELECTRICAL CHARACTERISTICS
S5 INTERFACE PIN CONNECTION
ta6 INTERFACE TIMING
a7 BLOCK DIAGRAM
.D8 MECHANICAL SPECIFICATION
9 OPTICAL CHARACTERISTICS
w10 RELIABILITY TEST CONDITION
w11 INSPECTION STANDARDS
w12 HANDLING PRECAUTIONS FOR TFT-LCD MODULE
Page
1
2
3
4
4
7
8
12
13
15
17
18
19
m-- PACKAGING SPECIFICATION
.co-- PRODUCTS NUMBER LABELING FORMS
t4U-- LAMP UNIT FOR 8.4” VGA
22
26
28
www.DataSheeT-51638D084J-FW-A-AC (AC) No. 2004-0163
OPTREX CORPORATION
Page 1/34
1 page VCC-dip conditions:
1) When 2.6 V ≤ VCC < 3.0 V, td ≤ 10 ms
2) When VCC < 2.6 V
VCC-dip conditions should also follow the power and signals sequence.
VCC
td
*2) Typical current condition:
64- gray- bar-pattern
480 line mode
VCC = +3.3 V, fH=31.5 kHz, fV=60 Hz, fCLK= 25 MHz
(2) Backlight
ITEM
SYMBOL MIN. TYP. MAX. UNIT
Ta = 25°C
Remarks
Lamp Voltage
VL -- 450 -- Vrms
IL = 6.5 mArms
Lamp Current
IL 3.0 6.5 7.0 mArms
*1),*5)
Lamp Frequency
FL 30 -- 60 kHz
*2)
Starting Lamp Voltage
VS 670 --
-- Vrms
Lamp Life Time
LT 50000 --
--
h
*3),*4) IL = 6.5 mArms,
Continuous Operation
*1) Lamp Current measurement method (The current meter is inserted in low voltage line.)
CTL A
LCD
Module
CTH
CTL
A
Inverter
Power
Supply
CTH
*2) Lamp frequency of inverter may produce interference with horizontal synchronous frequency, and
this may cause horizontal beat on the display. Therefore, please adjust lamp frequency, and keep
inverter as far from module as possible or use electronic shielding between inverter and module to
avoid the interference.
*3) Lamp life time is defined as the time either when the brightness becomes 50% of the initial value, or
when the starting lamp voltage does not meet the value specified in this table.
*4) The life time of the backlight depends on the ambient temperature. The life time will decrease under
low/high temperature.
T-51638D084J-FW-A-AC (AC) No. 2004-0163
OPTREX CORPORATION
Page 5/34
5 Page (4) Display Position and Scan Direction
D(X,Y) shows the data number of input signal for LCD panel signal processing PCB.
SC: Low
SC: High
D(1,1)
D(640,1)
CN2
D(640,480)
D(1,480)
CN2
D(1,480)
D(640,480)
CN3
D(640,1)
D(1,1)
CN3
T-51638D084J-FW-A-AC (AC) No. 2004-0163
OPTREX CORPORATION
Page 11/34
11 Page |
Páginas | Total 17 Páginas | |
PDF Descargar | [ Datasheet T-51638D084J-FW-A-AC.PDF ] |
Número de pieza | Descripción | Fabricantes |
T-51638D084J-FW-A-AB | LCD Module | OPTREX |
T-51638D084J-FW-A-AC | LCD_Module | OPTREX |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |