DataSheet26.com

SAM9G10 PDF даташит

Спецификация SAM9G10 изготовлена ​​​​«ATMEL Corporation» и имеет функцию, называемую «ARM-based Embedded MPU».

Детали детали

Номер произв SAM9G10
Описание ARM-based Embedded MPU
Производители ATMEL Corporation
логотип ATMEL Corporation логотип 

30 Pages
scroll

No Preview Available !

SAM9G10 Даташит, Описание, Даташиты
Features
Incorporates the ARM926EJ-S™ ARM® Thumb® Processor
– DSP Instruction Extensions
– ARM Jazelle® Technology for Java® Acceleration
– 16-Kbyte Data Cache, 16-Kbyte Instruction Cache, Write Buffer
– 293 MIPS at 266 MHz
– Memory Management Unit
– EmbeddedICE, Debug Communication Channel Support
Additional Embedded Memories
– 32 Kbytes of Internal ROM, Single-cycle Access at Maximum Bus Speed
– 16 Kbytes of Internal SRAM, Single-cycle Access at Bus Speed
External Bus Interface (EBI)
– Supports SDRAM, Static Memory, NAND Flash and CompactFlash®
LCD Controller
– Supports Passive or Active Displays
– Up to 16-bits per Pixel in STN Color Mode
– Up to 16M Colors in TFT Mode (24-bit per Pixel), Resolution up to 1280 x 860
USB
– USB 2.0 Full Speed (12 Mbits per second) Host Double Port
• OHCI Compliant
• Dual On-chip Transceivers
• Integrated FIFOs and Dedicated DMA Channels
– USB 2.0 Full Speed (12 Mbits per second) Device Port
• On-chip Transceiver, 2 Kbyte Configurable Integrated FIFOs
Bus Matrix
– Handles Five Masters and Five Slaves
– Boot Mode Select Option
– Remap Command
Fully Featured System Controller (SYSC) for Efficient System Management, including
– Reset Controller, Shutdown Controller, Four 32-bit Battery Backup Registers for a
Total of 16 Bytes
– Clock Generator and Power Management Controller
– Advanced Interrupt Controller and Debug Unit
– Periodic Interval Timer, Watchdog Timer and Real-time Timer
– Three 32-bit PIO Controllers
Reset Controller (RSTC)
– Based on Power-on Reset Cells, Reset Source Identification and Reset Output
Control
Shutdown Controller (SHDWC)
– Programmable Shutdown Pin Control and Wake-up Circuitry
Clock Generator (CKGR)
– 32,768 Hz Low-power Oscillator on Battery Backup Power Supply, Providing a
Permanent Slow Clock
– 3 to 20 MHz On-chip Oscillator and two PLLs
Power Management Controller (PMC)
– Very Slow Clock Operating Mode, Software Programmable Power Optimization
Capabilities
– Four Programmable External Clock Signals
AT91SAM
ARM-based
Embedded MPU
SAM9G10
6462B–ATARM–6-Sep-11









No Preview Available !

SAM9G10 Даташит, Описание, Даташиты
Advanced Interrupt Controller (AIC)
– Individually Maskable, Eight-level Priority, Vectored Interrupt Sources
– Three External Interrupt Sources and One Fast Interrupt Source, Spurious Interrupt Protected
Debug Unit (DBGU)
– 2-wire USART and support for Debug Communication Channel, Programmable ICE Access Prevention
– Mode for General Purpose Two-wire UART Serial Communication
Periodic Interval Timer (PIT)
– 20-bit Interval Timer plus 12-bit Interval Counter
Watchdog Timer (WDT)
– Key Protected, Programmable Only Once, Windowed 12-bit Counter, Running at Slow Clock
Real-Time Timer (RTT)
– 32-bit Free-running Backup Counter Running at Slow Clock
Three 32-bit Parallel Input/Output Controllers (PIO) PIOA, PIOB and PIOC
– 96 Programmable I/O Lines Multiplexed with up to Two Peripheral I/Os
– Input Change Interrupt Capability on Each I/O Line
– Individually Programmable Open-drain, Pull-up Resistor and Synchronous Output
– Schmitt Trigger on All Inputs
Nineteen Peripheral DMA (PDC) Channels
Multimedia Card Interface (MCI)
– SDCard/SDIO and MultiMediaCardCompliant
– Automatic Protocol Control and Fast Automatic Data Transfers with PDC, MMC and SDCard Compliant
Three Synchronous Serial Controllers (SSC)
– Independent Clock and Frame Sync Signals for Each Receiver and Transmitter
– I²S Analog Interface Support, Time Division Multiplex Support
– High-speed Continuous Data Stream Capabilities with 32-bit Data Transfer
Three Universal Synchronous/Asynchronous Receiver Transmitters (USART)
– Individual Baud Rate Generator, IrDA® Infrared Modulation/Demodulation
– Support for ISO7816 T0/T1 Smart Card, Hardware and Software Handshaking, RS485 Support
Two Master/Slave Serial Peripheral Interface (SPI)
– 8- to 16-bit Programmable Data Length, Four External Peripheral Chip Selects
One Three-channel 16-bit Timer/Counters (TC)
– Three External Clock Inputs, Two multi-purpose I/O Pins per Channel
– Double PWM Generation, Capture/Waveform Mode, Up/Down Capability
Two-wire Interface (TWI)
– Master Mode Support, All Two-wire Atmel EEPROMs Supported
– Compatibility with Standard Two-wire Serial Memories
– One, Two or Three Bytes for Slave Address
– Sequential Read/Write Operations
– Master, Multi-master and Slave Mode Operation
– Bit rate: up to 400 Kbits
– GEneral Call Supported in Slave Mode
IEEE® 1149.1 JTAG Boundary Scan on All Digital Pins
Required Power Supplies:
– 1.08V to 1.32V for VDDCORE and VDDBU
– 3.0V to 3.6V for VDDOSC and for VDDPLL
– 2.7V to 3.6V for VDDIOP (Peripheral I/Os)
– 1.65V to 3.6V for VDDIOM (Memory I/Os)
Available in a 217-ball LFBGA RoHS-compliant Package
2 SAM9G10
6462B–ATARM–6-Sep-11









No Preview Available !

SAM9G10 Даташит, Описание, Даташиты
SAM9G10
1. Description
The SAM9G10 is a complete system-on-chip built around the ARM926EJ-S ARM Thumb pro-
cessor with an extended DSP instruction set and Jazelle Java accelerator. It achieves 293 MIPS
at 266 MHz.
The SAM9G10 is an optimized host processor for applications with an LCD display. Its inte-
grated LCD controller supports BW and up to 16M color, active and passive LCD displays. The
External Bus Interface incorporates controllers for synchronous DRAM (SDRAM) and Static
memories and features specific interface circuitry for CompactFlash and NAND Flash.
The SAM9G10 integrates a ROM-based Boot Loader supporting code shadowing from, for
example, external DataFlash® into external SDRAM. The software controlled Power Manage-
ment Controller (PMC) keeps system power consumption to a minimum by selectively
enabling/disabling the processor and various peripherals and adjustment of the operating
frequency.
The SAM9G10 also benefits from the integration of a wide range of debug features including
JTAG-ICE, a dedicated UART debug channel (DBGU). This enables the development and
debug of all applications, especially those with real-time constraints.
6462B–ATARM–6-Sep-11
3










Скачать PDF:

[ SAM9G10.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
SAM9G10ARM-based Embedded MPUATMEL Corporation
ATMEL Corporation
SAM9G15AT91SAM ARM-based Embbedded MPUATMEL Corporation
ATMEL Corporation
SAM9G15-EKUser GuideATMEL Corporation
ATMEL Corporation

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск