DataSheet26.com

AS111 PDF даташит

Спецификация AS111 изготовлена ​​​​«Micross» и имеет функцию, называемую «Voltage Comparator».

Детали детали

Номер произв AS111
Описание Voltage Comparator
Производители Micross
логотип Micross логотип 

21 Pages
scroll

No Preview Available !

AS111 Даташит, Описание, Даташиты
Voltage Comparator
AVAILABLE AS MILITARY
SPECIFICATIONS
• SMD 5962-86877
• M38510/10304B
• MIL-STD-883, 1.2.1
FEATURES
• Operates from single 5V supply
• Input current: 150 nA max. over temperature
• Offset current: 20 nA max. over temperature
• Differential input voltage range: ±30V
• Power consumption: 135 mW at ±15V
OPTIONS
• Packages
8 pin Ceramic DIP
14 pin Ceramic DIP
20 pin Ceramic LCC
8 Lead Metal Can
• Temperature Ranges
Extended (-55oC to +125oC)
MIL-STD-883 paragraph 1.2.1
(-55oC to +125oC)
MARKINGS
C008
C014
E020
TO08
XT
/883
GENERAL DESCRIPTION
The AS111 is a voltage comparator that has input currents
nearly a thousand times lower than other similar devices like.
It is also designed to operate over a wider range of supply
voltages: from standard ±15V op amp supplies down to the
single 5V supply used for IC logic. Their output is compatible
with RTL, DTL and TTL as well as MOS circuits. Further,
they can drive lamps or relays, switching voltages up to 50V
at currents as high as 50 mA.
Both the inputs and the outputs of the AS111 can be
isolated from system ground, and the output can drive loads
referred to ground, the positive supply or the negative supply.
Offset balancing and strobe capability are provided and out-
puts can be wire OR’ed. Although slower than some devices
(200 ns response time vs 40 ns), this device is also much less
prone to spurious oscillations.
For more products and information
please visit our web site at
www.micross.com
AS111
Rev. 1.7 01/10
1
Voltage
Comparator
AS111
PIN ASSIGNMENT
(Top View)
8 Pin Ceramic DIP (C008)
GND 1
INPUT+ 2
INPUT-
V-
3
4
8 V+
7 OUTPUT
6 BALANCE/
STROBE
5 BALANCE
14 Pin Ceramic DIP (C014)
NC 1
GND 2
INPUT+ 3
INPUT- 4
NC 5
V- 6
BALANCE 7
14 NC
13 NC
12 NC
11 V+
10 NC
9 OUTPUT
8 BSTARLOABNECE/
8 Lead Metal Can (TO08)
GND 1
INPUT+ 2
INPUT- 3
V+
8
7 OUTPUT
6 BALANCE/STROBE
5 BALANCE
V4 -
20 Pin Ceramic LCC (E020)
Micross Components reserves the right to change products or specications without notice.









No Preview Available !

AS111 Даташит, Описание, Даташиты
TYPICAL APPLICATIONS3
Voltage
Comparator
AS111
AS111
Rev. 1.7 01/10
Micross Components reserves the right to change products or specications without notice.
2









No Preview Available !

AS111 Даташит, Описание, Даташиты
TYPICAL APPLICATIONS (CONTINUED)3
Voltage
Comparator
AS111
NOTE: Do Not Ground Strobe Pin
NOTE 2: Typical input current is 50pV with inputs strobed off.
NOTE 3: Pin connections shown on schematic diagram and typical applications are for TO08 metal can package.
ABSOLUTE MAXIMUM RATINGS*,5
Total Supply Voltage (V84)................................................36V
Output to Negative Supply Voltage (V74)..........................50V
GDrifofuenrednttoiaNl IengpautitvVeoSltuapgpel..y..V...o..l.t.a..g..e...(.V...1.4..)..............................................±..3300VV
Input Voltage4..................................................................±15V
Output Short Circuit Duration........................................10 sec
Lead Temperature (Soldering, 10 sec)...........................260°C
Voltage at Stobe Pin.....................................................V+ -5V
*Stresses greater than those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device. This
is a stress rating only and functional operation of the device
at these or any other conditions above those indicated in the
operation section of this specication is not implied. Exposure
to absolute maximum rating conditions for extended periods
may affect reliability.
Note 4: This rating applies for ±15 supplies. The positive input voltage limit is 30V above the negative supply. The negative input voltage limit is equal to
the negative supply voltage or 30V below the positive supply, whichever is less.
Note 5: The maximum junction temperature of the AS111 is 150°C. For operating at elevated temperatures, devices in the TO08 package must be derated
based on a thermal resistance of 165°C/W, junction to ambient, or 20°C/W, junction to case. The thermal resistance of the dual-in-line
package is 110°C/W, junction to ambient.
AS111
Rev. 1.7 01/10
Micross Components reserves the right to change products or specications without notice.
3










Скачать PDF:

[ AS111.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
AS1100Serially Interfaced 8-Digit LED DriverAMSCO
AMSCO
AS1101(AS1101 - AS1104) Low-Dropout LED DriversAMSCO
AMSCO
AS1102(AS1101 - AS1104) Low-Dropout LED DriversAMSCO
AMSCO
AS1103(AS1101 - AS1104) Low-Dropout LED DriversAMSCO
AMSCO

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск