XRS10L220 PDF даташит
Спецификация XRS10L220 изготовлена «Exar Corporation» и имеет функцию, называемую «SERIAL ATA II: PORT MULTIPLIER / PORT SELECTOR». |
|
Детали детали
Номер произв | XRS10L220 |
Описание | SERIAL ATA II: PORT MULTIPLIER / PORT SELECTOR |
Производители | Exar Corporation |
логотип |
30 Pages
No Preview Available ! |
EXSTOR - 1 XRS10L220
SERIAL ATA II: PORT MULTIPLIER / PORT SELECTOR
AUGUST 2008
REV. 1.02
FEATURES
GENERAL FEATURES
• Four independent 3/1.5Gbps SATA ports.
• Connects 2 host ports to 2 device ports.
• Supports 3/1.5Gbps rate detection/speed
negotiation.
• Supports power down modes - Active, partial,
slumber and power down.
• Advanced features configurable through MDIO
bus.
PORT MULTIPLIER/SELECTOR LOGIC FEATURES
• Low latency architecture.
• Supports OOB signaling for SATA applications.
Internal OOB detectors for COMRESET/
COMINIT and COMWAKE.
HIGH SPEED I/O FEATURES
• High speed outputs with programmable pre-
emphasis to drive long interconnects.
• Selectable high speed input equalization for
optimum reception.
• Compliant with SATA Gen-2i & Gen-2m
specification.
• Enables reliable data transmission over 1 meter
of FR-4 and 4 meters or more of unequalized
copper cable.
• Supports spread spectrum clocking (SSC) to
reduce EMI.
PHYSICAL FEATURES
• CMOS 0.13 Micron Technology
• Single 1.2 V Power Supply
• -40°C to 85°C Industrial Temperature Range
• No heatsink or airflow required
• 100-Pin LQFP Package
1.0 INTRODUCTION
The XRS10L220 provides the combined advantages
of the Serial ATA II Port Selector and Port Multiplier
implementations for Serial ATA II systems at 3.0
Gbps and 1.5 Gbps. Combining the capability to
address two Serial ATA devices from one external link
with support for a failover path from two independent
hosts, the XRS10L220 offers a leading solution for
propagation of high data rate Serial ATA products in a
wide variety of applications. The integration of Serial
ATA PHY links, a variety of digital logic capabilities,
rate adjust FIFOs, integrated low-cost clock oscillator
support, test and loopback features is achieved in a
low cost and lower power implementation.
The port selector function is used when dual hosts,
such as I/O controllers, must access single-port disk
drives in high availability storage subsystems where
redundancy and load sharing are important. The
outputs from the I/O controllers are multiplexed to a
Serial ATA drive through the port selector block of the
XRS10L220. Active/passive port selector in
XRS10L220 allows two different host ports to connect
to the same target in order to create a redundant path
to that target. In combination with RAID, the
XRS10L220 allows system providers to build fully
redundant solutions. This avoids the presence of a
single point of failure, and enables a fail-over path in
the case of host failure.
This port multiplier function is used when one active
host has to communicate with multiple SATA drives.
The XRS10L220 supports up to 2 SATA drives and
utilizes the full bandwidth of the host connection.
The XRS10L220 includes enhanced features such as
staggered HDD spin-up, power management control,
hot plug capability and support for legacy software.
The XRS10L220 acts as a retimer, maintaining
independent signaling domains between the drives,
hosts and the external interconnect.
The high-speed serial input feature: selectable
equalization adjustment and the high-speed serial
output feature: programmable pre-emphasis can be
used to compensate for ISI (Inter-Symbol
Interference) and increase maximum cable distances.
XRS10L220 meets tight jitter budgets in SATA
applications. Exar's serial I/O technology enables
reliable data transmission over 1 meter of FR-4 and 4
meters of unequalized copper cable.
Host and drive port speeds can be mixed and
matched, based upon inherent data rate negotiation
present in the SATA II specifications.
The MDIO bus allows simple configuration of the
XRS10L220 when needed. Receive equalization,
transmit amplitude and pre-emphasis and SSC
control are all configurable via the 2-wire MDIO
interface.
To summarize, the port multiplier functionality in the
XRS10L220 allows the system designer to increase
the number of serial ATA connections in an enclosure
that does not have a sufficient number of serial ATA
Exar Corporation 48720 Kato Road, Fremont CA, 94538 • (510) 668-7000 • FAX (510) 668-7017 • www.exar.com
No Preview Available ! |
EXSTOR - 1 XRS10L220
SERIAL ATA II: PORT MULTIPLIER / PORT SELECTOR
REV. 1.02
connections for all of the drives in the enclosure. The port selector functionality in the XRS10L220 allows
replacement for expensive Fibre Channel drives with cost effective and high capacity SATA drives in enterprise
class applications without compromising on redundancy or performance.
STANDARDS COMPLIANCE
The XRS10L220 is compliant with the following industry specifications:
• Serial ATA, Revision 1.0a
• Serial ATA II: Extensions to Serial ATA 1.0a, Revision 1.2
• Serial ATA II PHY Electrical Specifications, Revision 1.0
• Serial ATA II: Port Selector, Revision 1.0
• Serial ATA II: Port Multiplier, Revision 1.2
• Serial ATA II: Revision 2.6
APPLICATIONS
• Serial ATA Enclosures
• Other Serial ATA link replicator applications
• Buffers for externally connected links
• High density storage boxes
• RAID Subsystems
APPLICATION EXAMPLE
The XRS10L220 is ideally suited for use within an external drive enclosure as a means of providing redundant
host access to ensure system availability and reliability, while enabling access to up to two target devices per
XRS10L220. This application is shown in Figure 1. Other applications for the XRS10L220 include use in fixed-
content or network attached storage systems, storage arrays, desktop applications or entry-level servers,
RAID storage or disk-to-disk backup.
FIGURE 1. SYSTEM BLOCK DIAGRAM FOR XRS10L220 IN A DRIVE ENCLOSURE APPLICATION
DRIVEENCLOSURE
XRS10L220
SATA
Port Port
Selector Multiplier
SATA
2
No Preview Available ! |
REV. 1.02
FIGURE 2. PINOUT OF THE XRS10L220
EXSTOR - 1 XRS10L220
SERIAL ATA II: PORT MULTIPLIER / PORT SELECTOR
HBACT
PS_SIDEBAND_B
VSS
VDD
VSS
SiTN1
SiTP1
VDD
SiRN1
SiRP1
VSS
VDDA
VSSA
VSS
SiRP0
SiRN0
VDD
SiTP0
SiTN0
VSS
TCK
TMS
VDD
TDO
TDI
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
XRS10L220
50 VDDA
49 RBias
48 VSSA
47 CMU_REFN
46 CMU_REFP
45 VDDA
44 XOG
43 XOD
42 VSSA
41 SCANMODE
40 NC
39 NC
38 VDD
37 NC
36 NC
35 VSS
34 VDDA
33 VSSA
32 VSS
31 NC
30 NC
29 VDD
28 NC
27 NC
26 VSS
3
Скачать PDF:
[ XRS10L220.PDF Даташит ]
Номер в каталоге | Описание | Производители |
XRS10L220 | SERIAL ATA II: PORT MULTIPLIER / PORT SELECTOR | Exar Corporation |
Номер в каталоге | Описание | Производители |
TL431 | 100 мА, регулируемый прецизионный шунтирующий регулятор |
Unisonic Technologies |
IRF840 | 8 А, 500 В, N-канальный МОП-транзистор |
Vishay |
LM317 | Линейный стабилизатор напряжения, 1,5 А |
STMicroelectronics |
DataSheet26.com | 2020 | Контакты | Поиск |