AR0130CS Datasheet PDF - ON Semiconductor
| Part Number | AR0130CS | |
| Description | 1/3-Inch CMOS Digital Image Sensor | |
| Manufacturers | ON Semiconductor | |
| Logo |  |
|
|
There is a preview and AR0130CS download ( pdf file ) link at the bottom of this page. Total 30 Pages | ||
Preview 1 page No Preview Available !
‡
AR0130CS: 1/3-Inch CMOS Digital Image Sensor
Features
1/3-Inch CMOS Digital Image Sensor
AR0130CS Datasheet, Rev. 12
For the latest datasheet, please visit www.onsemi.com
Features
• Superior low-light performance both in VGA mode
and HD mode
• Excellent Near IR performance
• HD video (720p60)
• On-chip AE and statistics engine
• Auto black level calibration
• Context switching
• Progressive Scan
• Supports 2:1 scaling
• Internal master clock generated by on-chip phase
locked loop (PLL) oscillator.
• Parallel output
Applications
• Gaming systems
• Video surveillance
• 720p60 video applications
General Description
ON Semiconductor's AR0130 is a 1/3-inch CMOS digi-
tal image sensor with an active-pixel array of 1280H x
960V. It captures images with a rolling-shutter readout.
It includes sophisticated camera functions such as
auto exposure control, windowing, and both video and
single frame modes. It is programmable through a sim-
ple two-wire serial interface. The AR0130 produces
extraordinarily clear, sharp digital pictures, and its
ability to capture both continuous video and single
frames makes it the perfect choice for a wide range of
applications, including gaming systems, surveillance,
and HD video.
Table 1:
Key Parameters
Parameter
Optical format
Active pixels
Pixel size
Color filter array
Shutter type
Input clock range
Output clock maximum
Output Parallel
1.2 Mp (full FOV)
Max.
Frame
rates
720pHD (reduced FOV)
VGA (full FOV)
VGA (reduced FOV)
800 x 800 (reduced
FOV)
Responsivity at 550 nm (Mono)
Responsivity at 550 nm (RGB
green)
SNRMAX
Dynamic range
Supply
voltage
I/O
Digital
Analog
Power consumption
Operating temperature
Package option
Typical Value
1/3-inch (6 mm)
1280 x 960 = 1.2 Mp
3.75 m
Monochrome, RGB Bayer
Electronic rolling shutter
6 – 50 MHz
74.25 MHz
12-bit
45 fps
60 fps
45 fps
60 fps
60 fps
6.5 V/lux-sec
5.6 V/lux-sec
44 dB
82 dB
1.8 or 2.8 V
1.8 V
2.8 V
270 mW (1280x720 60
fps)
–30°C to + 70°C (ambient)
–30°C to + 80°C (junction)
Bare die, iLCC, PLCC
AR0130CS/D Rev. 12, 1/16 EN
1 ©Semiconductor Components Industries, LLC 2016.
|
| |
 
AR0130CS: 1/3-Inch CMOS Digital Image Sensor
Functional Overview
Figure 2:
provides further data path corrections and applies digital gain). The pixel data are
output at a rate of up to 74.25 Mp/s, in parallel to frame and line synchronization
signals.
Typical Configuration: Parallel Pixel Data Interface
Digital Digital
I/O core
power1 power1
PLL Analog Analog
power1 power1 power1
VDD_IO VDD
VDD_PLL VAA VAA_PIX
Master clock
(6–50 MHz)
From
Controller
EXTCLK
SADDR
SDATA
SCLK
TRIGGER
OE_BAR
STANDBY
RESET_BAR
Reserved
DGND
VDD_IO
VDD VDD_PLL VAA VAA_PIX
Digital
ground
DOUT [11:0]
PIXCLK
LINE_VALID
FRAME_VALID
To
controller
AGND
Analog
ground
Notes:
1. All power supplies must be adequately decoupled.
2. ON Semiconductor recommends a resistor value of 1.5k, but a greater value may be used for
slower two-wire speed.
3. This pull-up resistor is not required if the controller drives a valid logic level on SCLK at all times.
4. ON Semiconductor recommends that VDD_SLVS pad (only available in bare die) is left unconnected.
5. ON Semiconductor recommends that 0.1μF and 10μF decoupling capacitors for each power supply
are mounted as close as possible to the pad. Actual values and results may vary depending on lay-
out and design considerations. Check the AR0130 demo headboard schematics for circuit recom-
mendations.
6. ON Semiconductor recommends that analog power planes are placed in a manner such that cou-
pling with the digital power planes is minimized.
7. I/O signals voltage must be configured to match VDD_IO voltage to minimize any leakage currents.
AR0130CS/D Rev. 12, 1/16 EN
5 ©Semiconductor Components Industries, LLC, 2016.
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for AR0130CS electronic component. |
| Information | Total 30 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ AR0130CS.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| AR0130CS | The function is 1/3-Inch CMOS Digital Image Sensor. ON Semiconductor | |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
AR01
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||